WALL-MOUNTED DX CONTROLLER

• supply voltage: 220…240 V AC
• admissible load: 6 (3) A
• range of temp. setting: 10…30°C
• adjustment precision: +/- 1°C
• protection degree: IP30
• mounting method: surface mounting
• working environment temperatures: -10…+50°C

ATTENTION!

• one wall mounted controller DX can serve one air curtain DEFENDER WH
• maximum cable length from a curtain to a controller is 100 m
• minimum suggested wire diameter is 1mm²

Wall mounted controller can work in different configurations:
1. Control of the fan and the “heating” depending on the thermostat, the thermostat in such a solution affects the work of the entire system.
2. Control the fan independently to the thermostat, in such a solution it only affects the work of the fan.
3. These two configurations of the device are also possible in cooperation with a door switch.

ACTUATOR

• supply voltage: 230 V AC +/- 10%
• closing/opening time: 5/11s
• position without supply: closed
• protection degree: IP44
• working environment temperature: 2…40°C

VALVE

• operation mode: two positions: close / open
• maximum pressure difference: 100 kPa
• pressure class: PN 16
• kvs flow ratio: 3.5 m³/h
• max. heating medium temperature: 105°C
• ambient temperature: 2…40°C

It is recommended to mount a two-way valve on the return pipeline.

ATTENTION!

The diagram for the configuration of the controller operations can be found in technical documentation addend to each purchased curtain or on the website. Electrical wires from a possible additional automation control (thermostat, door switch, wall-mounted driver) should be run on separate tracks cable, non-parallel with power lines. The drawings are only the visualization of the given element of automation.